DDR2 SDRAM or double-data-rate two synchronous dynamic random access memory is a random access memory technology used in electronic engineering for high speed storage of the working data of a computer or other digital electronic device.
It is a part of the SDRAM (synchronous dynamic random access memory) family of technologies, which is one of many DRAM (dynamic random access memory) implementations, and is an evolutionary improvement over its predecessor, DDR SDRAM.
Its primary benefit is the ability to operate the external data bus twice as fast as DDR SDRAM. This is achieved by improved bus signaling, and by operating the memory cells at half the clock rate (one quarter of the data transfer rate), rather than at the clock rate as in the original DDR. DDR2 memory at the same clock speed as DDR will provide the same bandwidth but markedly higher latency, providing worse performance.
Like all SDRAM implementations, DDR2 stores memory in memory cells that are activated with the use of a clock signal to synchronize their operation with an external data bus. Like DDR before it, DDR2 cells transfer data both on the rising and falling edge of the clock (a technique called "double pumping"). The key difference between DDR and DDR2 is that in DDR2 the bus is clocked at twice the speed of the memory cells, so four bits of data can be transferred per memory cell cycle. Thus, without speeding up the memory cells themselves, DDR2 can effectively operate at twice the bus speed of DDR.
DDR2's bus frequency is boosted by electrical interface improvements, on-die termination, prefetch buffers and off-chip drivers. However, latency is greatly increased as a trade-off. The DDR2 prefetch buffer is 4 bits deep, whereas it is 2 bits deep for DDR and 8 bits deep for DDR3. While DDR SDRAM has typical read latencies of between 2 and 3 bus cycles, DDR2 may have read latencies between 4 and 6 cycles. Thus, DDR2 memory must be operated at twice the bus speed to achieve the same latency.
Another cost of the increased speed is the requirement that the chips are packaged in a more expensive and more difficult to assemble BGA package as compared to the TSSOP package of the previous memory generations such as DDR SDRAM and SDR SDRAM. This packaging change was necessary to maintain signal integrity at higher speeds.
Power savings are achieved primarily due to an improved manufacturing process through die shrinkage, resulting in a drop in operating voltage (1.8 V compared to DDR's 2.5 V). The lower memory clock frequency may also enable power reductions in applications that do not require the highest available speed.
According to JEDEC the maximum recommended voltage is 1.9 volts and should be considered the absolute maximum when memory stability is an issue (such as in servers or other mission critical devices). In addition, JEDEC states that memory modules must withstand up to 2.3 volts before incurring permanent damage (although they may not actually function correctly at that level).
